Service of the Infiniti QX4 since 1996 of release
	1. Introduction
	2. Maintenance instruction
	3. Routine maintenance
	4. Engine
	5. Cooling system and heating
	6. Feed and control systems
	7. Systems of start and charge
	8. Transmission line
		8.1. 4-staged automatic transmission
			8.1.1. General information
			8.1.2. Failure diagnostics of AT - the general information
			8.1.3. Electronic and hydraulic control system of 4-staged AT
			8.1.4. Removal and installation of transmission
			8.1.5. Replacement of an epiploon of lengthening of transmission
			8.1.6. Removal and installation of a cooler of ATF
			8.1.7. Removal and installation of valvate assembly of a hydraulic contour of management of AT
			8.1.8. Removal, check of a state and installation of a driving cable of blocking of switchings
			8.1.9. Adjustment of the drive of switching of AT
			8.1.10. Adjustment of the sensor switch of provisions of AT/permission of start
			8.1.11. Capital repairs of AT
		8.2. Transfer case
		8.3. Differentials, power shafts / half shafts
		8.4. Driveshafts
	9. Brake system
	10. Suspension bracket and steering
	11. Body
	12. Electric equipment

8-1-8-snyatie-proverka-sostoyaniya-i-ustanovka-privodnogo-trosa-blokirovki-pereklyuchenijj.html

8.1.8. Removal, check of a state and installation of a driving cable of blocking of switchings

Details of installation of a driving cable of blocking of switching

PERFORMANCE ORDER

Release the ram from the holder of the regulator and disconnect a cable from a driving rod.
Connect a cable to the lock of blocking of a steering column.
Latch a cable in clamps and by means of a collar connect to the operating cable. Transfer the selector lever to situation "P".
Fill a driving rod in the holder of the regulator.
Record a cable casing cover in a basic arm. By means of the ram record the holder of the regulator on a rod.