Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
8.1. 4-staged automatic transmission
8.1.1. General information
8.1.2. Failure diagnostics of AT - the general information
8.1.3. Electronic and hydraulic control system of 4-staged AT
8.1.4. Removal and installation of transmission
8.1.5. Replacement of an epiploon of lengthening of transmission
8.1.6. Removal and installation of a cooler of ATF
8.1.7. Removal and installation of valvate assembly of a hydraulic contour of management of AT
8.1.8. Removal, check of a state and installation of a driving cable of blocking of switchings
8.1.9. Adjustment of the drive of switching of AT
8.1.10. Adjustment of the sensor switch of provisions of AT/permission of start
8.1.11. Capital repairs of AT
8.2. Transfer case
8.3. Differentials, power shafts / half shafts
8.4. Driveshafts
9. Brake system
10. Suspension bracket and steering
11. Body
12. Electric equipment
 












8-1-5-zamena-salnika-udlineniya-transmissii.html

8.1.5. Replacement of an epiploon of lengthening of transmission

 PERFORMANCE ORDER

  1. Remove the transfer case from the car (see. Transfer case).
  2. Remove a back epiploon.
  1. Grease sponges new an epiploon of pure ATF, then fill its landing nest and press by means of a cylindrical mandrel.

As a mandrel the replaceable face head of the corresponding size, or a piece of a pipe of suitable diameter can approach.

  1. Further installation is made as it should be, the return to an order of dismantle of components.


"on the page back
8.1.4. Removal and installation of transmission
on the following page"
8.1.6. Removal and installation of a cooler of ATF




5d7aa768