Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a state and replacement of brake lines and hoses
9.4. Replacement of blocks of disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (MBC)
9.9. Removal and installation of assembly of the vacuum amplifier of brakes
9.10. Pumping of the brake system
9.11. Adjustment of the drive of the parking brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve regulator (LSV), sensitive to loading
9.14. Adjustment of sensors switches of stoplights and tempostata
9.15. Removal and installation of the ABS hydromodulator
9.16. Removal and installation of the G-sensor
9.17. Check of serviceability of functioning of wheel ABS sensors
9.18. Check of serviceability of functioning of the G-sensor
9.19. Check of serviceability of functioning of the relay of a driving electric motor of the hydromodulator
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator
10. Suspension bracket and steering
11. Body
12. Electric equipment
 






5d7aa768






9-11-regulirovka-privoda-stoyanochnogo-tormoza.html

9.11. Adjustment of the drive of the parking brake

 PERFORMANCE ORDER

    Prop up forward wheels antiretractable boots, release the parking brake, then a back of the car and establish to a poddomkratta it on props (see the illustration Scheme of an Institution of Props for fixing of the car in the lifted situation). Under the car release the regulator of a driving cable of the parking brake. At the working engine several times squeeze out a pedal of a foot brake before the termination of the clicking sounds in back brake mechanisms. Cock the lever of the drive of the parking brake on 4 — 7 clicks and tighten the regulator of the hummock drive. Count the number of clicks of a ratchet at procrastination of the lever with effort about 20 kgfs. The nominal rate makes 6 — 8 clicks. Release the parking brake and check freedom of rotation of back wheels. In case of need make adjustment of the sensor switch of a control lamp of the parking brake.


"on the page back
9.10. Pumping of the brake system
on the following page"
9.12. Adjustments of a pedal of a foot brake