Service of the Infiniti QX4 since 1996 of release
1. Introduction
2. Maintenance instruction
3. Routine maintenance
4. Engine
5. Cooling system and heating
6. Feed and control systems
7. Systems of start and charge
8. Transmission line
9. Brake system
9.1. Specifications
9.2. System of anti-blocking of brakes (ABS) - the general information and codes of malfunctions
9.3. Check of a state and replacement of brake lines and hoses
9.4. Replacement of blocks of disk brake mechanisms of forward wheels
9.5. Removal and installation of a support of the disk brake mechanism
9.6. Removal and installation of a brake disk
9.7. Replacement of brake boots of drum brake mechanisms of back wheels
9.8. Removal and installation of the main brake cylinder (MBC)
9.9. Removal and installation of assembly of the vacuum amplifier of brakes
9.10. Pumping of the brake system
9.11. Adjustment of the drive of the parking brake
9.12. Adjustments of a pedal of a foot brake
9.13. Adjustment of a spring of the valve regulator (LSV), sensitive to loading
9.14. Adjustment of sensors switches of stoplights and tempostata
9.15. Removal and installation of the ABS hydromodulator
9.16. Removal and installation of the G-sensor
9.17. Check of serviceability of functioning of wheel ABS sensors
9.18. Check of serviceability of functioning of the G-sensor
9.19. Check of serviceability of functioning of the relay of a driving electric motor of the hydromodulator
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator
10. Suspension bracket and steering
11. Body
12. Electric equipment
 






5d7aa768






9-19-proverka-ispravnosti-funkcionirovaniya-rele-privodnogo-ehlektromotora-gidromodulyatora.html

9.19. Check of serviceability of functioning of the relay of a driving electric motor of the hydromodulator

The relay of an electric motor is a part of the block of the ABS relay which at negative results of check is subject to replacement assembled.


Check of the block of the ABS relay

 

 PERFORMANCE ORDER

    Disconnect from the ABS relay block an electrical wiring (see the illustration Scheme of an Arrangement on the car of the ABS elements). Check existence of conductivity between the plug No. 10 and No. No. 4 and 15 of the block of the relay (see the illustration Check of the Block of the ABS Relay). If conductivity is absent in both cases, pass to the following stage of check, otherwise replace the block. Give the battery tension (12 V) between plugs No. No. 5 and 8 and repeat the previous check. This time conductivity has to take place, otherwise the block is subject to replacement. Remove stress from the block and measure resistance between plugs No. No. 5 and 8. The nominal rate makes 70.8 — 157.8 Ohms. The faulty block is subject to replacement.


"on the page back
9.18. Check of serviceability of functioning of the G-sensor
on the following page"
9.20. Check of serviceability of functioning of the relay of the electromagnetic valve of the hydraulic ABS modulator